Realtek Connector Settings: Be sure to checkmark Mute Rear Panel Output. Realtek Analog: (Automatically detects line in and line out.) Under the microphone settings, mute the Noise Supression and Acoustic Echo Cancellation. In the 3D Audio Demo tab, select Manual – Vertical under Moving Path. Under Realtek HD audio input, mute the stereo mix. Important New Tip: These settings will pertain to you if Realtek is your audio manager. First click on the Mixer tab.

The microphone mysteriously mutes itself sometimes. Also, make sure the microphone is not muted. Make sure nothing is muted (and the volume is turned up). If this is not checked, EchoLink will not work.ĮchoLink - Tools – Adjust Sound Device - Playback If you are using an Interface in Sysop Mode, make sure Digital Mode Interface is checked (RIGblaster or similar), if this is the type of interface you are using. Put the port numbers in the router settings. Make sure you do checkmark it where it says EchoLink this will allow it to work. If your ports are working and you still have trouble, this could be the culprit.Īlso make sure this has been done. The firewall must be set on low regarding your Internet Service Provider settings. If you don’t want anymore headaches, enable these ports also. These ports use to be the main ones until 57972 was suggested. But, just in case there is trouble, enable these ports. This port is supposed to be the magic one that works.

Setup - Portforwarding - Portforwarding Configuration – If you’re not familiar with this, call your ISP and they will walk you through. If a port setting isn’t right, you must go to the service page of your Internet Service Provider. This is a great tool to find your problem! Download this to your computer, in the My Documents Folder for example. Try this first before you do anything else, this should get you results.Īnother great idea: Download the EchoLink Troubleshooter. This will tell if you have configured something wrong. At the bottom of the Tools bar, you will see the Firewall/Router Test. If you cannot connect to the EchoLink Test Server or any other operator, it is highly likely that you do not have the port settings right, or the firewall setting on your computer isn’t set right. Remember–even after you have configured the port settings, the ports can come undone and have to be set again. Most of the time this usually is the problem. If it says Pass, you are okay with ports. Go to EchoLink - Tools - Firewall/Router Test Here are a few tips that especially apply to Windows XP, using a broadband connection. Troubleshooting EchoLink can be a very frustrating game. EchoLink Consejos para solucionar problemas

Echolink receiver settings